Production Update

July 09, 2017

Production Update

Testing and finalizing thermoforming molds has been more tedious and time-consuming than anticipated - but we are finally getting close. Thanks to all for your patience with this process, we want the molds to be perfect. The following video shows the thermoforming process, which is pretty cool. We have one last correction to the base wall mold to correct an area where the wall is not quite thick enough — this will take place this week and will be tested also. Crossing our fingers that this is final adjustment to mold, and then we will be running sets of 50 units. Will blog again to let everyone know how this final test goes and then on to production. 





Leave a comment

Comments will be approved before showing up.


Also in News

We Are Into Production Runs, Assembly, and Shipping!
We Are Into Production Runs, Assembly, and Shipping!

July 19, 2017

Our final adjustments to thermoforming molds were a success and we are now into production runs, assembling sluices, and will begin shipping units out Friday afternoon...

View full article →

Explorer and Nugget Sluices formed
Explorer and Nugget Sluices formed

June 30, 2017

Adding a quick photo of first 40 Explorer and Nugget sluice forms...

View full article →

Production, Assembly, and Shipping
Production, Assembly, and Shipping

June 26, 2017

After some stops and goes on getting full production going, we are now underway on launching products. Miscellaneous parts are ready for assembly, including over 1,000 rods for grizzlies...

View full article →